192.168.1.2 is an IP address that is usually used by some manufacturers to give users the access to their IP gateway. By using this IP address, you can access you are web interface by which you can configure your router’s main settings. This local ipv4 address can change your router’s default password, network refresh rate, other SSID configuration.
So in this article, we will learn more about this 192.168.1.2 IP address. How to login to it how to use it to change your router settings, and how to reset your router if you forget the default credentials. Let’s start the process.
How To Access 192.168.1.2 IP Address
You are the simple steps which you need to follow to access this IP gateway.
- First, you will have to enter this http://192.168.1.2 IP in your browser address bar or simply click on “Access Router Panel” button mentioned below.
- It does not matter whether you do this on your PC or your smartphone. As long as your device connected to the same router WiFi network, it will work fine. The only requirement is that your browser must be capable of handling HTML 5 pop-ups. If you have any device which is not more than 3 years old, it will work just fine.
- Once you have entered this IP address in the address bar, hit enter. Now press enter and you will be prompted to enter your user id and password. Here, you will have to enter the default user id and the default password for your router which has been provided by the manufacturer. In case you forgot then check out this guide to recover.
- Yes, I do not know what your default login credentials are, you will just have to refer them below list. All the required login credentials along with their respective manufacturers have been listed below. Just click on the drop-down menu and select your router’s brand.
Once you have entered the proper credentials, you should be able to directly login to the main page of your router’s firmware. From there, you can pretty much change or access any setting and reflect the changes in the router’s behavior.
Just make sure that you do not mess around with the advance settings which you do not know what you might end up screwing up your Internet connection and would probably have to call your ISP to get it fixed.
There are some aspects of your router which you may not be able to access because you like the administrative authority to change the settings. To get the administrator privileges will just have to log in with the admin user id and password. Doing that is straightforward. There is no secret password to be logged in as an administrator, believe it or not.
Just have to type the IP address in the address bar and hit enter once again. When you are ready to enter the user id and password, type admin in both fields and hit enter. It works every time on my D-Link ADSL router. I’m sure it’s the same thing for pretty much all the router which use the 192.168.1.2 IP gateway. Similarly, you can go for traditional IPs too such as 192.168.0.1 or 192.168.1.1.
Default Router Username & Password List
You can check any router’s default username & password from the drop-down list below.
What To Do If You Have Forgotten The User Id And Password
It happens to everyone. You might have recently change the default login credentials of your router and now we have forgotten them. If you have forgotten the user ID or password or both, you will not be able to login to the routers web interface anymore. Easy solution for that is to reset your router to the factory default settings simply.
To do that, you will have to find a small reset button which is present on your rotors body somewhere. Usually its present on the bottom. It is a pinhole-sized button which will have to press and hold for about 10 seconds using a pencil or a sharp tool, such as a toothpick. After this you will get new settings.
This was of the General information regarding this 192.1 68.1.2 IP address. Hope you found this useful and now know how to get more out of your router by changing its settings to some tried and tested values, that better than the defaults. Cheers!